Precision, Performance, Confidence. ™

DMM Connector on molbox1 Rear Panel

See this document to use the DMM connector on the molbox1 or molbox1+ flow terminal with the MFC option. This might be used to connect a reference DMM with better uncertainty in voltage than the MFC option on the molbox1 or molbox1+ terminal. 

The DMM connector always outputs volts (never current). 

When a MFC profile in volts is used, the measured voltage is a direct reading from the corresponding pins on the 25-pin MFC connector. 

When a MFC profile in current is used, the measured voltage is the current from the corresponding pins on the 25-pin MFC connector that is run through a 250 ohm (±0.01%) resistor on the MFC board inside the molbox1 or molbox1+ terminal. The resistance of this resistor can be measured on pins 1 to 4 of J3 on the MFC board if desired. 

Have more questions? Submit a request

Comments

Please sign in to leave a comment.