0

Exporting UUT output into an external file

I am scripting a Tektronix MSO2024B and ran into troubles during the calibration of the digital MSO input channels. I'm trying to query whether the digital signal was triggering high or low based upon it's input signal. I sent an e-mail to Tektronix asking them how to do this (there was no direct command for this) and their suggestion was to use the CURVE? command. Trouble is, this query is massive and cannot be dumped into any of the Met/Cal memory registers.

Is it possible to dump this output directly into an external file to then manipulate accordingly? Conversely, I'm open to suggestions if any one knows a better way.

1 comment

Date Votes
0
Avatar
HIDEO KOMATSU

IEEE2 and SCPI

[I > filename] read from current address, write to file

 

Please sign in to leave a comment.