0

Keithley 2400 Script for 5522A Errors During 4 wire Resistance


4 comments

Date Votes
0
Avatar
Chad D.

Hello Mac, I do not understand the nature of your post. Can you please elaborate? Are you asking for help with your own procedure code, or reporting an error in a Fluke Warranted procedure?

0
Avatar
Mac Cyr

It is a Fluke code, unsure of the warranted status, I downloaded it right out of Fluke's procedures page and I have not modified it.

0
Avatar
Mac Cyr

Apparently what I wrote in the description did not show up... so here it is again.

I downloaded the "Keithley 2400 1 yr Verification IEEE 5522A, DMM" procedure and continue to get the below error when running the Resistance Measurement 4 wire test between 20ohm-20kohm.  The error occurs on both of my 5522A calibrators but not on my 5520A.  All of which were just recently calibrated at Fluke and no problems were found.

Error Reads "E2075: Fluke 5522A:104, "Hardware relay trip occurred"."

1
Avatar
Chad D.

Thank you, Mac, the missing text helps a lot. I am going to convert this into a software support ticket so they can assist. You should get a ticket notification in just a moment.

Please sign in to leave a comment.